Page 1 of 1

Heat Sink Attachment

PostPosted: 08 Mar 2016, 21:16
by rwensley
Greetings,

The Motor Driver 6A-256 has the power supply capacitors in a most inconvenient location leaving no good way to add a heatsink to the top.

Assuming the board uses heat vias, is the a picture available of the bottom of the board and pads for mounting a heat sink there?

Thanks,
Ron Wensley

Re: Heat Sink Attachment

PostPosted: 09 Mar 2016, 09:53
by Support
You can use rubber flacks to fill the space between vias and the sink. Use thermal paste.

Heat Sink Attachment

PostPosted: 12 Jun 2016, 18:53
by Vikapolyak
I see that there is a new and larger heat sink that removes the need for a fan. Is there a place I could order these from?

P.S.:
ЕСЛИ ЧТО-ТО НЕПОНЯТНО ВСЕГДА СМОТРИ СЮДА!

Re: Heat Sink Attachment

PostPosted: 13 Jun 2016, 09:03
by Support
Unfortunately we do not offer them. You can find them in some used electronic housing or circuits.

Heat Sink Attachment

PostPosted: 23 Sep 2017, 05:44
by ElaizaHob
thats a great idean i never thought of that.
Thank you for the reply
Dan