Stepper Motors with Plane CNC Control box not working

Motors, motor drivers, power supplies, ...

Stepper Motors with Plane CNC Control box not working

Postby Ravihotwok » 25 Jul 2017, 08:46

Hello

I have just wired in my stepper motors with 4 cables which are wired to the correct coil pairs, when I have plugged them into the control box they do not seem to be working. As soon as power is applied to the control box the motors make a high pitch noise, when you try and jog on the computer the motors seem to try and move but tend to go back and fourth as if they are resisting themselves. I have not changed anything on the software from installing it.

Here is a vid:

https://youtu.be/Fy4FmoKrYf0

I have the main control box that planet sell with the mk3/4 board.

Any help would be most appreciated

Kind regards

Ravi
Ravihotwok
 
Posts: 3
Joined: 21 Jun 2017, 07:59

Return to Electronics



Who is online

Users browsing this forum: No registered users and 1 guest