SPU ISSUES

SPU ISSUES

Postby adstaggs » 06 Dec 2016, 03:50

WHEN I TRY TO SETUP SPU AND GET TO THE STEP TO ENTER X10 TO MAKE X AXIS TO MOVE 10MM IT MOVES ALMOST THE FULL LENGTH OF THE TABLE, WHAT AM I MISSING/
adstaggs
 
Posts: 2
Joined: 26 Sep 2016, 18:18
Controller: Mk2

Re: SPU ISSUES

Postby Support » 09 Dec 2016, 05:25

Please post your settings file.

Have you read this: http://planet-cnc.com/how-to-setup-cnc/
Support
 
Posts: 2571
Joined: 07 Apr 2014, 17:39
Controller: Many controllers

Re: SPU ISSUES

Postby adstaggs » 11 Dec 2016, 01:10

I was able to fix the issue I think, I adjusted PoStep 25-32 to 1/8 and ran the axis calibration and needed to adjust Steps/Units to 40.000 but I am not sure that is the right settings. I have attached the settings file.
Attachments
CNCUSB.settings.setting
SETTINGS FILE
(40.75 KiB) Downloaded 12 times
adstaggs
 
Posts: 2
Joined: 26 Sep 2016, 18:18
Controller: Mk2


Return to Mk2/4 controller



Who is online

Users browsing this forum: No registered users and 1 guest