Page 1 of 1

Stop Problems

PostPosted: 29 Nov 2016, 22:00
by Kveavve
Hey! Has now connected up my cnc machine, but have a problem suggesting fault setting. When I drive axes to test, everything stops after 10-15 seconds no matter how I do. Everything is connected away and I must then disconnect the power and wait a few minutes before trying again .. This happens every time ..
Have NEMA 23 motors 425 oz. has set these at 1/128 steps.
How many steps do I need to enter the program at this setup?
Hope someone can help me, do not know what this padding may depend ..

Kveavve

Re: Stop Problems

PostPosted: 30 Nov 2016, 10:48
by Support
Please post your settings file and picture of your controller.

Re: Stop Problems

PostPosted: 30 Nov 2016, 11:23
by Kveavve
I have a china breakoutboard, and my steps setting is on 200..

Re: Stop Problems

PostPosted: 30 Nov 2016, 20:25
by Kveavve
Here comes some pictures of general settings..
These problems came after I adjusted repeatedly dip switches on microstepping driver .. Think it was a time when it was set to the current 0.5 A ..
but now I have current of 3.0 A and 1/128 steps ..