Stop Problems

General topics about everything that doesn't fit elsewhere.

Stop Problems

Postby Kveavve » 29 Nov 2016, 22:00

Hey! Has now connected up my cnc machine, but have a problem suggesting fault setting. When I drive axes to test, everything stops after 10-15 seconds no matter how I do. Everything is connected away and I must then disconnect the power and wait a few minutes before trying again .. This happens every time ..
Have NEMA 23 motors 425 oz. has set these at 1/128 steps.
How many steps do I need to enter the program at this setup?
Hope someone can help me, do not know what this padding may depend ..

Kveavve
Kveavve
 
Posts: 4
Joined: 12 Nov 2016, 08:04
Controller: Other

Re: Stop Problems

Postby Support » 30 Nov 2016, 10:48

Please post your settings file and picture of your controller.
Support
 
Posts: 2571
Joined: 07 Apr 2014, 17:39
Controller: Many controllers

Re: Stop Problems

Postby Kveavve » 30 Nov 2016, 11:23

I have a china breakoutboard, and my steps setting is on 200..
Attachments
image.jpg
image.jpg (236.84 KiB) Viewed 477 times
Kveavve
 
Posts: 4
Joined: 12 Nov 2016, 08:04
Controller: Other

Re: Stop Problems

Postby Kveavve » 30 Nov 2016, 20:25

Here comes some pictures of general settings..
These problems came after I adjusted repeatedly dip switches on microstepping driver .. Think it was a time when it was set to the current 0.5 A ..
but now I have current of 3.0 A and 1/128 steps ..
Kveavve
 
Posts: 4
Joined: 12 Nov 2016, 08:04
Controller: Other


Return to General topics



Who is online

Users browsing this forum: No registered users and 1 guest