Control Box wiring help

Control Box wiring help

Postby rbedard77 » 29 Apr 2017, 11:58

Hey all, I am new to CNC's and could certainly use some help. I purchased the MK3 controller and the 344 enclosure with accesories. My question is more around the DB9 plugs and 4 pin aviation plugs on the enclosure. I would like to use the DB9 plugs for the motor drivers. I am not sure which wires go where on the male plug end coming from the table to the control box. Any ideas?
Posts: 1
Joined: 12 Apr 2017, 21:26
Controller: Mk3

Re: Control Box wiring help

Postby slbat » 19 Jun 2017, 20:21

Have you checked out the manual...You can download them. They're not too bad

Enclosure Build Part 1 ... _Part1.pdf

Enclosure Build Part 2 ... _Part2.pdf

If those don't address your exact concerns, you might have to use the MK3 Manual and extrapolate your you specifics.
MK3 Controller Manual - includes general wiring guidelines ... lerMk3.pdf

Lots of reading, Good Luck
Posts: 10
Joined: 22 May 2017, 20:39
Controller: Mk3

Return to Mk3 controller

Who is online

Users browsing this forum: No registered users and 1 guest