Output board query

Output board query

Postby molliemilo » 04 Oct 2017, 18:40

I have set up a huanyang VFD with a 2.2kw,using the Mk3/9axis controller and the planet cnc output board.When Idle, I have 10 volts to the VFD.I have started the spindle,using the toolbar icon and it shows me a speed of aprox 14,000 rpm, with a voltage of 5.8 volts.Problem is,it only runs for about 6 seconds and the relay then cuts out.I can re-start,but after a very short time,cuts out again.Have followed the tutorial to the letter and am now at a loss.Am using the 10 pin ribbon cable with pin 5 for on/off and pin 6 for speed.Any suggestions
molliemilo
 
Posts: 4
Joined: 04 Oct 2017, 18:18
Controller: Mk3

Re: Output board query

Postby Support » 05 Oct 2017, 14:42

viewtopic.php?f=2&t=10240
Support
 
Posts: 2655
Joined: 07 Apr 2014, 17:39
Controller: Many controllers


Return to Mk3 controller



Who is online

Users browsing this forum: Bing [Bot] and 1 guest