diy MK1 no response

diy MK1 no response

Postby soslhg » 30 Nov 2016, 15:54

According to this article http://planet-cnc.com/diy/

I use this schematic http://planet-cnc.com/wp-content/upload ... Silviu.pdf

I use this bootloader http://planet-cnc.com/wp-content/upload ... 100111.zip

There are four documents, I have tried each, after downloading boot, when the usb connected to the computer, there is no response.

This is not a driver issue, because the computer did not sound when I connect usb. And there is no change in the device manager.

After downloading the boot, I have tried [Connect Jog8 (RB4) to Vcc and Connect to USB].

Now,I do not know what to do...
soslhg
 
Posts: 3
Joined: 30 Nov 2016, 15:08
Controller: DIY Mk1

Re: diy MK1 no response

Postby Support » 01 Dec 2016, 12:34

Was boot-loader successfully uploaded? You did not have any problem? Your PCB is correct and all elements are correct and soldered properly?

Try this USB driver with your latest sw version:
http://old.planet-cnc.com/files/CNCUSBC ... Driver.zip
Support
 
Posts: 2609
Joined: 07 Apr 2014, 17:39
Controller: Many controllers

Re: diy MK1 no response

Postby soslhg » 02 Dec 2016, 02:32

Support wrote:Was boot-loader successfully uploaded? You did not have any problem? Your PCB is correct and all elements are correct and soldered properly?

Try this USB driver with your latest sw version:
http://old.planet-cnc.com/files/CNCUSBC ... Driver.zip



uploaded no problem,only verify hava an error about eeprom。

I try to replace another new picf18f4550,but still eeprom error。

It's not driven's problem,because computer no sound when link usb cable.
the usb is no enum.
soslhg
 
Posts: 3
Joined: 30 Nov 2016, 15:08
Controller: DIY Mk1


Return to DIY



Who is online

Users browsing this forum: No registered users and 1 guest

cron